34
35
Pulling the stick backward will pitch the tail of the helicopter downward, allowing the helicopter to be flown
backward .
The elevator trim can be used to help keep the helicopter from drifting forward or backward when in hover with
no elevator stick input . For example, if the helicopter drifts forward when in hover, pull the elevator trim downward
until the helicopter hovers as level as possible with no forward drifting .
Moving the stick to the left will roll the helicopter to the left, allowing the helicopter to be flown to the left .
Moving the stick to the right will turn (yaw) the nose of the helicopter to the to the right about the axis of the main
shaft . This is accomplished by increasing the speed of the tail rotor blade .
The rudder trim can be used to help keep the nose of the helicopter from rotating to the left or right when in hover
with no rudder stick input . For example, if the nose of the helicopter drifts to the right when in hover, add left
rudder trim until the nose stays as close to straight as possible . Also note that further adjustments to the rudder
trim can be made using the main motor proportional mix trimmer pot as outlined in the “Tail Rotor Proportional Mix
Trimmer Pot Adjustment” section of the manual .
The elevator stick controls (pitch fore/aft) . Pushing the stick forward will pitch the nose of the helicopter
downward, allowing the helicopter to be flown forward .
Mode 2
Mode 1
Mode 2
Mode 1
Mode 2
Mode 1
Nose Yaw Right
Helicopter Moves Forward
Helicopter Moves Backward
Mode 2
Mode 1
Helicopter Moves Left
Содержание Blade CP Pro 2
Страница 40: ...78 79 ...