10
11
Charge Errors and Indications
In the event that both the red and green LEDs flash, a charge error has occurred . Some examples of charge
errors and their indications include:
• Alternating flashing of the red and green LEDs will indicate that the charge process has been interrupted. If input
power to the charger has been interrupted due to disconnection from the power source or a drop in voltage/
current output from the power source, unplug the battery from the charger . Next, check to make sure that the
input power plug from the AC to 12V DC adapter/power supply is connected or that the alligator clips are firmly
and properly attached to the power source . Also be sure that the power source is providing the proper amount
of voltage and current required to the charger .
• After confirming the connections and that the power source is delivering the necessary voltage and current,
re-start the charge process by connecting the battery pack . Continue to monitor the charge process to ensure
that no further charge errors occur .
• Simultaneous flashing of the red and green LEDs will indicate that the voltage of the LiPo battery pack is too low
to allow the charge process to begin . In this case the battery may have been over-discharged due to flying the
model too long (for more information on preventing over-discharge of the LiPo battery pack, see the Battery
Warnings and Guidelines section), or that a single cell or even all cells in the battery pack may be damaged .
• If after several charging attempts you continue to see this charge error indication, you should remove the battery
pack from service and replace it with a new one .
If you have any further questions or concerns regarding charge error indications, please contact the Horizon
Support Team at 877-504-0233 .
Installing the Transmitter Batteries
Install the 4 included AA batteries in the transmitter . Check the power level of the batteries and operation of the
transmitter by switching the power switch on (upward) . The LCD screen at the top of the transmitter will indicate
the power level of the batteries . If at any time the voltage indicated on the LCD screen falls to 4 .5V or less, an
alarm will sound, and it will be necessary to replace the batteries with new ones .
Note: Because the HP6DSM transmitter included with the Blade CP Pro 2 is equipped with Spektrum 2 .4GHz
DSM2 technology, it does not require the same input voltage or current consumption as a typical 72MHz
transmitter for proper operation and optimum performance .
Installing the Flight Battery
Use the included hook and loop material for mounting the LiPo battery pack . We suggest installing the “loop”
(fuzzy) material on the battery pack and the “hook” material on the battery support. You should also use the
included rubber bands for the most secure attachment of the battery to the helicopter .
Содержание Blade CP Pro 2
Страница 40: ...78 79 ...