12
13
Input power for the charger can also be supplied by a small 12V gel cell or car battery using the
included wire harness with alligator clips.
The charger is equipped with four LED indicators marked as CELL 1, CELL 2, CELL 3 and CHARGE
STATUS on the label. These LEDs indicate the following (also found on the label of the charger):
• Red Solid CELL STATUS LEDs and Red Flashing CHARGE STATUS LED:
Input power connected,
battery to charge not connected
• Green Solid CELL Status LEDs and Red Solid CHARGE STATUS LED:
Battery to charge connected
and charging, balance between cells OK
• Yellow Solid CELL STATUS LED and Red Solid CHARGE STATUS LED:
Charging and balancing cell
with yellow LED
• Red Solid CELL STATUS LEDs and Red Solid CHARGE STATUS LED:
Charge complete
• Red and Green Flashing CELL STATUS LEDs and Red Solid (or flashing) CHARGE STATUS LED:
Charge error
Use care to ensure proper polarity (as marked on the bottom of the charger case) when connecting
the charger to a power source. Once you have connected the charger to the power source, its CELL
STATUS LEDs will glow solid red and the CHARGE STATUS LED will flash to indicate the charger has
power and is ready to begin charging. Connect the Li-Po battery to the charger using the specially
marked Balance Charge Lead exiting the battery and the mating connector on the side of the charger
labeled with 11.1V. The balance connector is keyed to prevent reverse polarity connection.
Note: Be sure to place the battery and charger on a smooth, heat-resistant surface during charging.
When the battery is properly connected and charging normally, the CHARGE STATUS LED will glow
solid red and the CELL STATUS LED indicators will glow solid green when the voltage balance between
the cells is OK. If the CELL STATUS LED for any cell is glowing yellow while the CHARGE STATUS LED is
solid red, the indicated cell will be balanced (charged) so its voltage closely matches that of the other
two cells and the “full” charge voltage. Once the battery has been fully charged, the CELL STATUS and
CHARGE STATUS LEDs will glow solid red. The battery can now be removed from the charger and
installed in the Blade 400 3D for flight.
Содержание Blade 400 3D
Страница 24: ...46 47 NOTES NOTES ...