Dynaxo DynaCook X2, Руководство пользователя

Страница: 41 / 51

Procedure in emergency situations
Alarm condition on the Control Panel
Signal Comments
No. Cause
Light Sound
1
Gas shortage – no flame
(incorrect operation of the
control equipment)
G letter constantly on
or G and H letters
flashing
Short signal every 2
seconds until the
system is unblocked
1.Make sure that gas is supplied through the gas supply
system, e.g. by checking if other has appliances are
working.
2.Keep touching LOCK sensor for at least 5 seconds
3.Try to start up the hob using any heating power sensor
three times.
4.If G letter is still displayed (assuming that gas is
supplied)
close the gas valve and call service center
.
2 User fault
F letter constantly on
Continuous 1 sec. beep
1.Switch off power supply for at least 20 seconds.
2.Check if the control panel on the ceramic hob is clean and if it is not covered by a pot or dirt.
3.Clean it.
4.Switch on power supply.
5.If F letter is still displayed, close the gas valve and call service center. .
3
Maximal allowable
temperature exceeded
(overheating)
F and H letters
flashing in turns
Short beep every 2
seconds for 30 seconds.
1. Switch off power supply and close the gas valve.
2. Wait at least 30 minutes until the hob cools down.
3. Open the gas valve and switch on power supply.
4. If F alarm condition still continues, switch off power supply, close the gas valve and call
service center