Dynaxo DynaCook X2, Руководство пользователя, Страница: 36 / 51

36
Automatic heating up function
The automatic heating up function is used to quickly bring up a dish (e.g. water) to the desired temperature at
the set cooking zone heating power.
A
dot displayed near the digit means that the hob works in the automatic heating up function.
5. How to switch the ceramic hob on in the automatic heating up function :
5.1. Switch on the ceramic hob using the ON/OFF sensor and touch
[ - ]
sensor which sets the heating
power to “
9.
”,
5.2. Keep touching
[ + ]
sensor until the heating power of the given cooking zone is set to “
9.
”,
6. To change the heating power in the automatic heating up mode, touch the
[ + ]
or
[ - ]
sensors; every
change of the heating power in the automatic heating up mode is confirmed by a dot displayed after the
digit showing the set heating power.
7. To switch off the automatic heating up mode for a given cooking zone, keep touching
[ - ]
sensor until the
power is set to “0” or touch both
[ + ]
and
[ - ]
sensors regardless of the set heating power.
8. The automatic heating up mode is switched off automatically (after a time depending on the set heating
power). The end of the automatic heating up function is confirmed by disappearance of dot shown on the
display near the cooking zone power digit, e.g. if the heating power is set to 9, the function continues for 30
minutes, and after that time the cooking zone goes into cyclic mode of operation.
FHZ System (Flexible Heating Zone)
The innovatory GCH 5.01.SD/2 ceramic gas hob has a system of cooking zones called Flexible Heating Zone
(FHZ). The FHZ cooking zone allows to use the zone for cooking in pots of various bottom diameter, ranging
from – to (see Table No. 2).
Table No. 2
Range of operation
(diameter) of the
cooking zone (FHZ)
from to
Cooking zone
no. on Fig. 1
(Hob view)
Total number of
cooking zones on
the hob
180 mm 220 mm 1 1
105 mm 160 mm 2 1
Gas leak protection
GCH 5.01.SD/2 ceramic hob has several systems
guaranteeing the highest possible standards of safety,
including a system protecting from gas leaks. It is a
proven and well-tested solution consisting in continuous
control of the gas burning process, using the ionization
phenomenon.
In case of any problems with initiation of the burning
process (e.g. broken spark generator) or any
disturbances in the gas burning process, the gas leak
protection system will immediately (within a fraction of a
second) cut off the gas supply. Thanks to a continuous
control of the gas burning process, the control panel
informs about any disturbances by showing “
G ” letter on
the heating power display of the cooking zone the
problem applies to and emitting a short beep. Such
condition automatically blocks the operation of the
appliance until the reason that trigged the protection is
found.
To find out how the cancel the protection
blockage see “
Procedure in emergency situations”
Tips:
“ G ” letter displayed may also result from
shortage of gas in the cylinder or the gas supply system.