Dynapac PL350 TD, Инструкция по эксплуатации

Страница: 53 / 107

Operation
IPL350TD-1EN2.pdf 2012-06-18
1
2
Fig. Swivel chassis leg
1. Pin
2. Bolt
Swivel chassis leg.
The right-hand chassis leg can be folded in to the side
of the machine when necessary.
The chassis leg's wheel must be held in the
correct position manually when being moved. The chassis leg's wheel must be held in the
correct position manually when being moved.
Lower the machine to ground level and raise up the
right-handed chassis leg to the upper position.
1. Pull out the pin and swing the chassis leg in towards
the machine.
2. Secure the chassis leg and insert the pin again.
1
Fig. 1. Direction of travel indication
Direction of steering indicator
The direction of steering indicator is located on the top
of the machine. The indicator is connected to the front
wheel's steering and shows the direction position of
the front wheel.
Pointer
2
1
Fig. Direction indicator
1. Stop screw 2. Wing nut
The milling lane indicator is located on the vehicle
frame. When folded out, it helps the driver to
maneuver the machine during milling.
The indicator's extension length is adjusted with stop
screws (1) and its height is adjusted with wing nuts (2).
45