Dynapac PL350 TD, Инструкция по эксплуатации

Страница: 52 / 107

Operation
IPL350TD-1EN2.pdf 2012-06-18
Fig. Control panel
2. Gear position switch 3. Speed limitation
4. Forward/Reverse lever 5. Gauges
2
3
4
5
- Put the gear position switch (2) in transport mode to
move the machine at transport speed.
= Transport gear = Transport gear
= Working gear = Working gear
The transport gear must only be used when
driving the machine on a smooth surface. The transport gear must only be used when
driving the machine on a smooth surface.
- Set the speed control for the engine (3) at full power.
Carefully move the forward/reverse lever (4) forwards
or backwards, depending on which direction of travel
is required. The speed increases the further the lever
is moved away from the neutral position.
The speed should always be controlled using the
forward/reverse lever and never by changing the
engine speed. The speed should always be controlled using the
forward/reverse lever and never by changing the
engine speed.
Check while driving that all the gauges (5) show
normal readings. Stop the planer and engine
immediately in the event of abnormal values. Check
and correct any faults; see also the section on
maintenance and the engine manual.
Driving on difficult surfaces
Drive wheels
Fig. Control panel
1 Gear position switch 2. Differential lock
position
1
2
If the machine should get stuck and the wheels start to
spin, put the control lever in the "Stop" position and
then put the gear position switch (1) in the "differential
lock" (2) position.
When the machine has regained its grip set the knobs
in their original positions.
When "differential lock" is activated it´s
impossible to turn the machine on the spot or to
drive around a sharp corner. When "differential lock" is activated it´s
impossible to turn the machine on the spot or to
drive around a sharp corner.
44