Dynapac PL350 TD, Инструкция по эксплуатации

Страница: 50 / 107

Operation
IPL350TD-1EN2.pdf 2012-06-18
1
Fig. Control panel
1. Forward/Reverse lever
2. Scraper
3. Milling drum drive
4. Ignition lock
5. Control lamp, preheating
3
2
4
5
Starting
Starting the engine
Make sure that the emergency stop is not activated.
Put the forward/reverse lever (1) in neutral, making
sure that the scraper is in the floating position (2) and
that other controls are in position 0.
The diesel engine cannot be started if the lever is in
another position.
Turn the ignition key (4) to position 1. Wait until the
preheating control lamp (5) has gone out, and then
turn the ignition key to pos. 2 to start the diesel engine.
Release as soon as the engine starts.
Do not run the starter motor for too long (max. 30
seconds). If the engine will not start, wait a
minute before trying again. Do not run the starter motor for too long (max. 30
seconds). If the engine will not start, wait a
minute before trying again.
Allow the engine to idle for a few minutes with no load
to warm up, longer if the air temperature is below
+10°C (50°F). The milling drum should be engaged.
Ensure that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning. Ensure that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
When starting and driving a cold machine with
cold hydraulic fluid, the braking distance will be
longer than when the fluid reaches normal
working temperature. When starting and driving a cold machine with
cold hydraulic fluid, the braking distance will be
longer than when the fluid reaches normal
working temperature.
42