Dynapac CP275, Инструкция по эксплуатации

Страница: 58 / 115

Miscellaneous
50
4812273203.pdf
2017-08-25
Fig. Positioning
1. Chocks
2. Blocks
3. Straps
The machine must only be lifted with a jack, or
the like, positioned as per the markings. The frame
is reinforced at these points to withstand the
tension.
Lifting at any other place can result in damage to
the machine or personal injury.
Roller prepared for transport
Activate the parking brake.
Make sure that the machine is in a neutral
position, i.e. that the front tires are pointing
forwards.
Chock the tiers (1) and secure the chocks to the
transport vehicle. The chock should have an angle
of 37° and minimum height of 25 cm (9.9 inches).
The tiers should be chocked both forwards and
backwards.
Block under the frame (2) to ensure tensioned
chains if the air goes out of the tires. Block up the
machine as shown in figure
Secure the roller with chains in all four corners.
The attachment points are shown on the decals.
Place the chains in symmetrical pairs crossing
each other.
Make sure that the chains, blocks and
attachments in the transport vehicle are
approved and have the requisite breaking
strain. Check at regular intervals that the
chains are not slack.