Dynapac CP275, Инструкция по эксплуатации

Страница: 100 / 115

Maintenance – 1000h
92
4812273203.pdf
2017-08-25
Fig. Hydraulic fluid filter
Fig. 1. Sight glass
1
Hydraulic filter
Change
The hydraulic filters are located on the left side in the
engine compartment, behind the battery disconnector.
Remove the filter and hand in to waste
disposal station. This is a disposable filter and
cannot be cleaned.
Thoroughly clean the filter holder sealing surface.
Apply a thin coat of fresh hydraulic fluid to the rubber
gasket on the new filter.
Screw the filter on by hand, firstly until the filter gasket
makes contact with the filter base. Then rotate a
further ½ turn.
Check the hydraulic fluid level in the sight glass (1)
and top off as required. See under the heading 'Every
10 hours of operation' for more information.
Start the engine and check that the filter does not leak.