Safety – When operating
7
4812273203.pdf
2017-08-25
Safety – When operating
Prevent persons from entering or remaining
in the danger area, i.e. a distance of at least 7 m (23
ft) in all directions from operating machines.
The operator may allow a person to remain in the
danger area, but should then observe caution and
operate the machine only when the person is
visible or has given clear indications of where he or
she is.
Slopes
This angle has been measured on a hard, flat surface
with the machine stationary.
The steering angle is zero, the tires have normal air
pressure and all the tanks are full.
Always take into consideration that loose ground, the
steering of the machine, different tire pressures, the
operating speed and that an increase in the center of
gravity can all cause the machine to topple even on
slopes with lesser gradients than those specified here.
To exit the cab in an emergency, release the
hammer on the rear right post and break the right
opening side-windows.
It is recommended that ROPS (Roll Over
Protective Structure) or a ROPS approved cab, is
always used when driving on slopes or unsafe
ground.
Always use the lowest gear when operating
on slopes.
Where possible, avoid driving across
slopes. Drive instead straight up and down sloping
ground.
Fig. Operating on slopes
Max. 15
°
or 27%
Содержание CP275
