Dynapac CP275, Инструкция по эксплуатации

Страница: 103 / 115

Maintenance – 2000h
95
4812273203.pdf
2017-08-25
Fig. Drain plugs
1. Hex nut
2. Bulkhead elbow
3. Hose
4. Drain plug
Maintenance – 2000h
Park the roller on a level surface.
When checking and making adjustments to the
roller, switch the engine off and make sure the
Forward/Reverse lever is in the Neutral position.
Ensure that there is good ventilation (air
extraction) if the engine is run indoors.
Risk of carbon monoxide poisoning.
Engine – Replace the coolant
The drain plug for the coolant is located at the back on
the right side of the machine. The drain plug can be
accessed by opening the panel in front of the exhaust
pipe.
Drain the coolant when the engine is warm. Place a
container that holds at least 14 liters (15qts) under the
drain plugs.
Observe caution when draining the
coolant. Wear protective gloves and goggles.
Release the hex nut (1) as shown (2).
Pull out the hose (3) and release the drain plug (4) for
the coolant. Allow all the coolant to run out into a
container.
To refit, secure the plug (4) as shown and push in the
hose.
Secure as shown and then tighten the hex nut (1).
Hand in the drained coolant to an
environment-friendly waste disposal station.