Dynapac CC 82, Руководство по обслуживанию

Страница: 21 / 27

19 CC82/92 M092EN3
Place the roller on a level surface. Switch
the engine off and push in the reserve/
parking brake knob for all checking and
adjustments on the roller, unless otherwise
specified.
Remove the oil filter (1) and discard it in a safe
manner; it is of the expendable type and
cannot be cleaned.
Thoroughly clean the sealing surface of the filter holder.
Apply a thin coat of fresh hydraulic fluid on the rubber
gasket of the new filter.
Screw on the filter by hand, first until the filter gasket
makes contact with the filter base and then a further ½
turn.
Start the engine and check that the filter does not leak.
Check the hydraulic fluid level in the sight glass (3) and
top off as required, see under the heading ”Every 10
hours of operation.”
Do not tighten the filters too hard, the seals
may otherwise be damaged.
Hydraulic fluid filters
– Changing
1
Fig. 27 Engine compartment, right-hand
side
1. Hydraulic filters
EVERY 500 HOURS OF OPERATION (Every three months)
WARNING
CAUTION