Dynapac CC 82, Руководство по обслуживанию

Страница: 19 / 27

17 CC82/92 M092EN3
Drum
– Checking the oil level
Position the roller on a flat surface and drive slowly until
the oil plug (1) is opposite the semi-circular recess in
the drum suspension.
Switch off the engine, break the electric
power supply and press the parking brake/
emergency stop knob.
Unscrew the plug and check that the oil level reaches
up to the lower edge of the filler hole. Fill as required
with fresh transmission oil, see under the heading
Lubricants for the correct grade of oil.
Clean off any metal particles from the magnetic oil plug
(1) and screw in the plug.
Forward/Reverse controls
– Checking and lubrication
Fig. 22 Forward/reverse controls
1. Friction screws
2. Screw
3. Operating wire
Check friction of the forward/reverse controls. Adjust
the friction screws (1) as required to retain the forward/
reverse controls at the set position during operation of
the roller. The zero mode of the controls is determined
by screw (2) gripping the groove in the spindle between
the two control levers.
If the controls begin to bind after a long period of use,
lubricate them at the bearings (1), and also lubricate the
control cable (3) with a few drops of oil at each position.
1
If the forward/reverse control is still stiff after the above
adjustment, lubricate the other end of the control cable
as well with a few drops of oil. The cable is located on
top of the propulsion pump.
Fig. 24 Drive side of drum
1. Oil plug
2
3
1
EVERY 250 HOURS OF OPERATION (Monthly)
Fig. 23 Engine compartment
1. F/R controls
2. Propulsion pump
1
2
WARNING