Dynapac CC 82, Руководство по обслуживанию

Страница: 20 / 27

18 CC82/92 M092EN3
Hydraulic reservoir
– Checking/venting
Fig. 25 Engine compartment, right-hand
side
1. Hydraulic reservoir, filler cap
Lift up the engine hood to its fully open position.
Unscrew and ensure that the reservoir cap is not
clogged; air must have unobstructed passage through
the cap in both directions.
If clogged in either direction, clean with a little diesel oil
and blow with compressed air until free passage is
assured, or replace the cap with a new one.
Wear protective goggles when working
with compressed air.
Switch off the engine, break the electric
power supply and press the parking brake/
emergency stop knob.
The alternator belt (3) is correctly stretched if it can be
pressed down about 10 mm (³3/8") at a position half
way between the pulleys. Proceed as follows if the belt
needs to be stretched.
Loosen the two hexagonal socket screws (1) and (2).
Push the alternator over to tension the belt to the size
mentioned above.
Tighten screw (1) first and then screw (2). Check to
make sure that the belt is stretched properly after
tightening the screws.
Fig. 26 Alternator viewed from the front
1. Adjusting screw
2. Mounting screw
3. Alternator belt
1
Alternator
– Checking and belt tension
3
2
1
EVERY 250 HOURS OF OPERATION (Monthly)
WARNING
WARNING