Dynapac CC 82, Руководство по обслуживанию

Страница: 22 / 27

20 CC82/92 M092EN3
Fig. 28 Left side of machine
1. Oil drain plug
2. Exhaust pipe
Drain condense water from the hydraulic reservoir via
the drain plug (1). Drain after the roller has stood still for
a longer period, eg, overnight.
Take care when draining. Do not drop the plug
so that the fluid flows out in an uncontrolled
manner.
Drain as follows:
Hold a can underneath the drain plug (1).
Loosen the plug and allow any water to run out.
Tighten the plug.
Fig. 29 Air cleaner
1. Wing nut
2. Cover
3. Nut
4. Backup filter
5. Filter housing
1
2
Hydraulic reservoir
– Draining
Toothed belt on vibration pump
– Checking the belt tension
Fig. 30 Engine compartment, right-hand
side
1. Toothed belt
Switch off the engine, break the electric
power supply and press the parking brake/
emergency stop knob.
Put your hand under the left hydraulic filter and feel the
top of the belt between the pulleys.
The belt is correctly stretched if it can be moved about
5 mm (³ 3/16") up or down.
Risk of injury by burning. Carry out this
check only when the engine is cold. Care-
fully follow the items below to avoid the
risk of injury by crushing.
Replace the main filter (3) of the air cleaner even if it has
not yet been cleaned five times; see under the heading
”Every 250 hours of operation” for changing the filter.
If the filter is not replaced when clogged, the
engine will emit smoke and lose power and
there will be serious risk of damage to the
engine.
Air cleaner – Changing
1
4 1
3
5
2
EVERY 1000 HOURS OF OPERATION (Every six months)
WARNING
WARNING
CAUTION
CAUTION