Page 39
Section 4 – Standard System Status and Controls
Dukane Manual Part No. 403-610-02
Pin
Signal Name
Connector
5
Setup Bit 0 Input
J5 (Page 19)
6
Setup Bit 1 Input
7
Setup Bit 2 Input
8
Setup Bit 3 Input
25
MPC Ready Out
J5 (Page 21)
Table 4 - II
MPC I/O Connector Signals
MPC Probe Control
When the optional MPC module and MPC I/O are used,
the generator has the capability of controlling as many
as sixteen compatible probes. One probe can be turned
on at a time while the sequence of probe activation is
determined by the user’s automation. Table 4-III shows
how the setup bit inputs correspond to the probes.
MPC I/O
Probe
Selected
3
2
1
0
Off
Off Off Off
1
Off
Off Off On
2
Off
Off On Off
3
Off
Off On On
4
Off
On Off Off
5
Off
On Off On
6
Off
On On Off
7
Off
On On On
8
On
Off Off Off
9
On
Off Off On
10
On
Off On Off
11
On
Off On On
12
On
On Off Off
13
On
On Off On
14
On
On On Off
15
On
On On On
16
Table 4 - III
MPC Setup Bit Inputs
Continued from Previous Page
CAUTION
Ultrasound Output Connector
The ultrasound output connector used with
all standard generators is a high voltage
(5000V) coaxial style SHV-BNC connector.
This connector provides superior shield-
ing of electrical noise, compared to other
types of connectors. The ultrasound output
connector mates with fully shielded coaxial
ultrasound cables that are secured with a
simple and reliable quarter-turn bayonet
style attachment mechanism.
The ultrasonic output from this connector
(that drives the attached ultrasonic load) is
a very high AC voltage. At high power levels
this can exceed 4 amps of current and must
be securely terminated via the ultrasound
cable for safe operation. Use original equip-
ment ultrasound cables for safe and reliable
system operation. Improperly assembled
ultrasound cables can result in high volt-
age arcing and will destroy the ultrasound
connectors.
Do not use the generator if there is any
evidence arcing (black carbon deposits) on
either the ultrasound output connector or the
ultrasonic cable connectors.
MPC I/O Connections
Signal names and Pin numbers and the connectors related
to the MPC option are shown in the table below. See the
pages referred to in the table for more information about
the signals.
