Page 38
iQ Series AiM
™
Automation in Mind
,
Ultrasonic Power Supply User’s Manual
Dukane Manual Part No. 403-610-02
Multi- Point Control (MPC)
Interface
The MPC Interface connector powers and controls an
external MPC module. This external module must be
purchased in addition to a basic generator for a fully
functional MPC system. It can be ordered with a minimum
of two probe controls and up to a maximum of 16 probe
controls.
MPC Interface Connector (J2)
Connections required for the external MPC module are
described below.
•
MPC I/O - MPC control/input signals and status out-
put signals are carried in the I/O cable that should
already be connected. See Table 4-I on Page 32 for
further information.
•
MPC INTERFACE - Attach one end of the MPC Inter-
face cable (Dukane # 200-1408-XX) to the
MPC
con-
nector on the
iQ
generator panel in Figure 4-2. Connect
the other end of the cable to the
MPC INTERFACE
connector on the right rear of the MPC module.
Continued
MPC INTERFACE CONNECTOR
Figure 4-2
J2 MPC Interface Connector
NOTE
The MPC Interface cable is a separate
line item on the iQ generator system
order. The -XX at the end of the cable
number specifies cable length. This will
vary depending on your MPC installation.
NOTE
This information is for the MPC/MPCQ
models only. If connecting to a MPC-E
models, see document 403-617 MPC-E
Multi-Point Controller Quick Start Guide.
Refer to Dukane’s website for more information about
the MPC-E Quick Start Guide at the link below:
