DSEGenset DSEA108, Руководство оператора

Страница: 7 / 58

Specifications
Page 7 of 58 057-281 ISSUE: 1
2 SPECIFICATIONS
2.1 REQUIREMENTS FOR UL CERTIFICATION
Description Specification
Conductors
CAUTION!: For applications in the US, the DSEA108 is rated as PD3 for
0 V to 430 V and PD2 for 430 V to 600 V. For applications in Canada, the
DSEA108 is rated as PD3 for 0 V to 300 V and PD2 for 300 V to 600 V
•
Conductor protection must be provided in accordance with NFPA 70, Article
240
•
Low voltage circuits (35 V or less) must be supplied from the engine starting
battery or an isolated secondary circuit.
•
The communication, sensor, and/or battery derived circuit conductors shall be
separated and secured to maintain at least ¼” (6 mm) separation from the
generator and mains connected circuit conductors unless all conductors are
rated 600 V or greater.
Current Inputs
•
Must be connected through UL Listed or Recognized isolating current
transformers with the secondary rating of 5 A max.
Communication
Circuits
CAUTION!: The communication port is for temporary use and service
access only by qualified service personnel only. Use appropriate Personal
Protective Equipment (PPE) during connection as risk of potential shock
hazard.
•
Must be connected to communication circuits of UL Listed equipment.
Mounting
•
Suitable for flat surface mounting in Open Type Device Enclosure Type rating
with surrounding air temperature -22 ºF to +158 ºF (-30 ºC to +70 ºC)
•
Suitable for pollution degree 3 environments when voltage sensing inputs do
not exceed 300 V. When used to monitor voltages over 300 V device to be
installed in an unventilated or filtered ventilation enclosure to maintain a
pollution degree 2 environment.
Operating
Temperature
•
-22 ºF to +158 ºF (-30 ºC to +70 ºC)
2.2 TERMINAL SPECIFICATION
Connection Type Description Specifiction
CAN port
Terminal Block
Two-part connector. Male
part fitted to module.
Female part supplied in
module packing case.
Minimum Wire Size 0.25 mm
2
(AWG 24)
Maximum Wire Size 3.0 mm
2
(AWG 12)
Tightening Torque
(Wire Clamp) 0.5 Nm
(4.42 lbf.in)
Tightening Torque
(Connector to Connector) 0.5 Nm
(4.42 lbf.in)
All other connections Spade Terminals
6.3 mm male spade
terminal fitted to module