DSC PC1150, Инструкция по эксплуатации

Страница: 26 / 38

Reset to Factory Default
Software Reset
Entering Section will reset the control panel’s programming to the default settings. When Section is
entered, the keypad will beep several times and the “Trouble” light will come ON during the reset sequence.
Hardware Reset
If the Installer’s Code forgotten and
a
software reset cannot be performed, the panel may be reset to the default
settings with the following method:
2
3
4
Remove all power, AC and battery, from the panel
Short the pins marked EEPROM RESET
While maintaining theshort, power-up the panel and wait least 10 seconds before removing the short
After at least 10 seconds, remove the short. The keypad buzzer will beep and the panel’s programming
will be reset to the default settings
4th System Option Code
Refer to Section for programming instructions.
LIGHT
ON = Able to answer call from downloading computer
l
OFF Cannot answer call from downloading computer
ON = Enable callback to downloading computer
. OFF = Disable callback to downloading computer
ON =
Enable answering machine over-ride
l
OFF = Disable answering machine over-ride
ON =
‘System” light flashes when armed to indicate alarm memory
l
OFF = “System” light normal
ON = Quick-Arm enabled
l
OFF = Quick-Arm disabled
ON Restore on siren time-out (if zone is restored)
l
OFF = Restore as follower (when zone restores)
[R] = ‘Ready” light; [A] = “Armed” light
l
Factory default
Downloading and Answering Machines
The answering machine override feature allows an answering machine to be connected to the same telephone
line as the control panel. Turn Light in Section ON to enable this feature.
To access the panel, have the downloading computer call the control panel and let the line ring for 1 or 2 rings
only. Hang up the line and then call the panel back within the time programmed in Section
the panel will
then answer the second call on the first ring.
If Light is OFF, it is assumed that there is no answering machine connected to the telephone line, and the
panel will capture the line after the set number of rings.
Note that if Light is OFF and an answering machine is connected to the line and is set to answer before the
panel, the panel will be unable to receive a call from the downloading computer. If the panel is set to answer
before the answering machine, the answering machine will be unable to receive incoming calls.
24
firealarmresources.com