Arming
Without Entry Delay
To
eliminate the Entry Delay, arm the system by entering
Access Code].
An exit through a Delay
Zone may be
as in normal arming. The system will arm as described in Auto-Bypass/ Home-Away arming
whether an exit is made or not. The “Armed” light will FLASH to indicate that the system is armed and that there
is no entry delay. If any zone is activated, an alarm will sound immediately.
Enter the premises through the designated Entry-Exit door. The keypad will sound a tone to indicate that the
system must be disarmed. Go to the keypad and enter an Access Code. If an error is made entering the code,
press the Key and enter the code again. The “Armed” light will be shut
the sounder will be silenced.
A valid Access Code must be entered before the Entry Delay expires or an alarm will sound. To change the
Entry Delay, refer to Installer’s Programming Section
If an alarm occurred while the panel was armed, the “System” light and the zone lights of the zones that went
into alarm will FLASH for two minutes. Press the
Key to cancel the flashing display and to return the panel
to the “ready” mode. Refer to
Alarm Memory Display.
Zone Bypassing
A bypassed zone will not cause an alarm. Use zone bypassing when access is needed to part of the protected
area or if damage to sensors or wiring cannot be repaired immediately. The panel can be armed with one or
more zones bypassed even if the zones are open. The “Ready” and “System” lights will be ON if a zone is
bypassed. Note that fire zones cannot be bypassed.
Enter
to display the bypassed zones;
Lights of bypassed zones will come ON. Ensure that any
zone displayed as being bypassed is intentionally bypassed. Zone bypasses are automatically cancelled
when the panel is disarmed.
To Bypass Zones:
Enter
the “System” light will start flashing.
Enter the number of the zone to be bypassed; the
zone light will come ON to indicate that the
zone is bypassed. To remove a bypass, enter the zone number and its zone light will be shut OFF. Enter the
zone numbers for all zones that are to be bypassed. Press [#] to return to “ready”.
To Recall Bypassed Zones:
Enter
This command will recall the last zone or group of zones that was bypassed. If the same group of zones are
bypassed regularly, the Recall feature can be used instead of bypassing the zones individually.
Bypass Disable:
The PC1 150 can be programmed by the installer to prevent certain zones from being bypassed. Lights for
these zones will not come ON in response to the bypass command. Refer to Section
Zone Bypass Mask.
Display Trouble Conditions
The PC1 150 continuously monitors a number of trouble conditions. If one of these conditions occurs, the
keypad “System” light will come ON and the sounder will sound two short beeps every 10 seconds.
To
silence
the sounder, press the
Key; the sounder will be silenced but the “System” light will remain ON until the trouble
condition is cleared. Refer to Section
Maintenance Alarms Restorals for a list of trouble conditions that
can be reported to the monitoring station.
7
firealarmresources.com
Содержание PC1150
Страница 36: ...firealarmresources com ...
