PROGRAMMING GUIDE
With the panel disarmed, enter
Code]. The default installer’s Code is 1212. The Installer’s
Code should be changed after the system is installed; refer to Section
Installer’s Code. Note that the panel
can only be programmed while it is disarmed.
When the Installer’s Programming Command is entered, the “System” light will FLASH to indicate that the panel
is ready
for
programming. NOTE: If no
key
entry is made for 2 minutes, the panel will return to the “ready” mode
and the Installer’s Programming Command will have to be entered again.
With the “System” light flashing, enter 2
digits for
the Section you wish to program; Programming Sections range
from
to
and each section is programmed independently.
Once the 2 digits for the Section you wish to program are entered, the keypad will beep 3 times; the system
is now ready to accept data for the selected Section. Most sections contain groups of 2-digit numbers; the
keypad will beep twice after each 2-digit number is entered.
When a Section is entered, the Zone Lights will indicate the value of the first digit in the Section in binary format
(see Binary Data Display). To change the first digit, enter a new digit from the keypad. If you wish to keep the
first digit unchanged,
same number. When the first digit has been entered, the Zone Lights will display
the value of the second digit.
When all data for the Section is completely entered, the keypad sounder will beep several times to indicate that
the expected data has been entered. When
iscompletely programmed, enter the number of the next
Section that is to be programmed.
It is not necessaryto program all 2-digit numbers in any given Section.
can be entered and selectively
programmed by going only to the digits you wish to change. After your changes have been made, press the
Key to return to the programming mode. You may then enter another Section for programming. For 2-digit
numbers, both digits must be programmed before pressing the [#] Key. Only the data entered before pressing
the Key will be changed in the EEPROM.
Program Data Review:
l
Enter the Installer’s Programming Command:
Code]
l
Enter the Section you wish to program by entering the 2-digit section number.
l
The 4 Zone Lights will represent the value, in binary format, of the first digit in the section.
l
At the end of the Section, the keypad will beep several times and then return to the program mode so that
another Section can be selected for review or programming.
Sections
These sections
you
to enable or disable various system functions. Refer to the Programming Worksheets
to see which features are represented by the Zone, “Ready” and “Armed” lights. If
a
feature is enabled, its Light
will be ON; if a feature is disabled, its Light will be OFF.
To enable or disable a feature, press a number from 1 to 6. If a feature is being enabled, its light will come ON:
if a feature is being disabled, its light will be shut OFF. All functions can be turned OFF at once by pressing
[O]. When all selections have been made, press
to save the changes and return to the program mode.
12
firealarmresources.com
Содержание PC1150
Страница 36: ...firealarmresources com ...
