FRONT MATTER
CONTENT
PAGE 4
9711-26400-0001
EXPORT CONTROLLED – SEE PAGE 3
Rev A
Canada
•
This Class B digital apparatus complies with Industry Canada ICES-003, Issue 4 June 7,
2004 and license-exempt RSS standards RSS-210, Issue No 8 (December 2010), RSS-
132 Issue No. 2 (September 2005), and RSS-133 Issue No. 5 (February 2009).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference that may cause undesired
operation of the device.
•
Cet appareil numérique de classe B est conforme à Industrie Canada ICES-003, numéro
4 Juin 7, 2004 et exempts de licence normes RSS RSS-210, Issue n ° 8 (Décembre
2010), CNR-132 fascicule n o 2 (Septembre 2005), et RSS-133 fascicule n ° 5 (Février
2009). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil
ne peut pas provoquer d'interférences et (2) cet appareil doit accepter toute interférence
pouvant causer un fonctionnement indésirable de l'appareil.
•
This product is restricted to indoor use in the 5.15 to 5.25 GHz frequency range. Industry
Canada requires this product to be used indoors to reduce the potential for harmful
interference to co-channel mobile satellite systems.
•
Operation in the 2.4 GHz band: To prevent radio interference to the licensed service, this
device is intended to be operated indoors and away from windows to provide maximum
shielding. Equipment (or its transmit antenna) that is installed outdoors is subject to
licensing.
•
Opération dans la bande 2,4 GHz:Pour empêcher que cet appareil cause du brouillage
au service faisant l'objet d'une licence, il doit être utilisé a l'intérieur et devrait être placé
loin des fenêtres afin de fournir un écran de blindage maximal. Si le matériel (ou son
antenne d'émission) est installé à l'extérieur, il doit faire l'objet d'une licence.
•
Be advised that high-power radars are allocated as primary users (i.e. priority users) of
the bands 5250–5350 MHz and 5650–5850 MHz and that these radars could cause
interference and/or damage to WLAN devices.
•
Under Industry Canada regulations, the WLAN radio transmitter may only operated
using an antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent isotropically radiated power (EIRP)
is not more than that necessary for successful communication.
•
This radio transmitter 7888B-622ANH has been approved by Industry Canada to operate
with the antenna types listed below with the maximum permissible gain and required
antenna impedance for each antenna type indicated. Antenna types not included in this
list, having a gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
o
Mobile Mark SMW-301-xxxx( surface mount), MGW-301-xxxx (magnetic
mount)radome antennas
o
Gain: +5dBi in 2.4GHz and 5GHz bands
o
Impedance: 50 ohm
