SECTION 5
YOUR ARMOR X7 SOFTWARE
PAGE 109
9711-26400-0001
EXPORT CONTROLLED – SEE PAGE 3
Rev A
R adio O N/O F F B uttons .
There is an
ON
and
an
Off
button for each radio that is installed or supported. When you first
start your ARMOR X7, all installed radios are ON or enabled (default condition). Each radio can
then be disabled by pressing its
OFF
button and re-enabled by pressing its
ON
button. Refer to
Enabling and Disabling Your Wireless Radios
for information on how to use these buttons.
NOTE:
Radio options that may be available but are not installed will appear here also.
Doc k R F S w B utton
The
Dock RF Sw
button enables or disables the antenna configuration that is selected by the
Dock RF Mux switch. The initial setting for the Dock RF switch is “Enable”. If the switch is set to
“Disable”, a docked tablet will use its internal antennas.
NOTE:
If the X7 does not sense a
vehicle dock, it will utilize its internal antennas regardless of the setting of the Dock RF Sw.
Doc k R F MUX S witc h
Your X7 contains an RF multiplexer circuit that is configured by the
Dock RF Mux
switch. There
are two RF coaxial connectors built into the base of the X7 dock: one for an external GPS
antenna and one for a WLAN (Wi-Fi) antenna (see
). Depending on the setting of
the
Dock RF Mux
switch, the RF multiplexer will automatically switch your GPS and/or WLAN
antennas to external antennas mounted on the vehicle whenever you dock the tablet.
You can select
GPS only
,
WLAN only
, or
Both
antennas. The default setting for the Dock RF
MUX switch is “Both”.
S ave S ettings B utton
Regardless of how you configure your radios with the
Radio ON/OFF
buttons during your
current session, they will return to their previously saved settings the next time you restart the
computer unless you save your current changes. The same is true with any changes to the
Dock RF or Dock RF Mux switches. You must click on the
Save Settings
button to save any
current changes as your new default settings.
