Docomo L-06A Prime Series, Инструкция по эксплуатации

Страница: 539 / 553

b
Enter "ユーザー名 (User Name)" and
"パスワード (Password)"▶Click [ダイ
ヤル (Dial)]
The access point will be connected.
• To connect to "mopera U" or "mopera", you can
leave the "ユーザー名 (User Name)" and "パスワ
ード (Password)" fields unfilled and click [ダイヤ
ル (Dial)]. If another ISP or dial-up connection is
selected, fill in the "ユーザー名 (User Name)" and
"パスワード (Password)" fields and click [ダイヤ
ル (Dial)].
• You can save the user name and password or
just the password to skip entering them next
time.
• Depending on the operating system, a
connection completion screen may appear when
the dial-up connection is established.
However, the connection completion screen
does not appear if you previously set the
completion message not to appear.
Disconnecting
Exiting the Internet browser may not terminate
the connection. Perform the following steps to
terminate the connection securely.
a
Click the dial-up icon in the
task tray of the PC
A screen indicating the connection status
appears.
b
Click [切断 (Disconnect)]
The communication will be terminated.
Note
• The communication speed shown on the
PC screen may be different from the actual
communication speed.
AT Commands
AT commands are used to check the FOMA
terminal function settings or status on a PC.
Usually the communication software issues AT
commands so that you do not have to be aware
of them. Use AT commands if you want to
control the FOMA terminal in your own way.
Format of AT Commands
AT commands should be entered on the
Terminal Mode screen of the communication
software such as Hyper Terminal.
• Terminal Mode is for sending text input on a PC to
the line connected to the communication port.
Example of Entry Format
ATD*99***1#
Hard Return
Parameter : Content of the
command.
Command Name
• An AT command must be entered on a single
line including parameters (numbers and symbols)
following the command. On the Terminal Mode
screen of the communication software, "one line" is
from the first character to the character prior to
.
You can enter up to 256 characters including the
AT command.
• Be sure to enter half-pitch alphanumeric characters
for the AT command, including any parameters that
follow the command.
• If the entered characters do not appear, enter ATE
.