Docomo L-06A Prime Series, Инструкция по эксплуатации

Страница: 451 / 553

Appendix/Troubleshooting
Symptom Check
Ring tone does
not sound • Is the ring tone volume for incoming voice/
videophone calls set to "Silent"? →P101
• Is Public mode (P76), Manner mode (P105),
or Self mode (P124) activated?
• Is Accept/Reject call (P95), Incoming call
(P123), Reject on list (P127), Reject all calls
(P128), Anonymous caller (P129), Set mute
ring(sec.) (P130), or Reject unknown (P130)
set?
• Is Set ring time for Voice Mail or Call
Forwarding service set to "0 Sec."?
→P393, P396
• Is answering time for Record message set to
"0 sec."?→P77
• Is Delayed time for Auto answer set to
"0 Sec."?→P372
Calls cannot be
made
(Ex.: "圏外" does
not disappear
even when you
move, or making/
receiving calls
is unavailable
although radio
wave is strong
enough) • Turn power off and on, or remove and install
battery pack or the UIM.
• Even when "FOMA terminal is not out of
service area" or "signal strength is shown as
", calls may not be made or received due to
the type of radio waves. Move and call again.
• Is incoming restriction such as Reject on list
(P127) or Accept/Reject call (P95) set?
• Depending on crossing of radio waves, calls
or mails are crossed at the crowded places
and connection status may not be good. In
this case, "Please wait for a while" appears
and the caller hears a busy tone. Move to
other place or call again later.
Symptom Check
Display is dim • Is the display duration in "Backlight" set
short?→P110
• Is "Display brightness" in "Backlight"
changed?→P110
• Is "Power saver mode" set to "ON"?→P111
• Is the battery running low? Charge the
battery.→P49
During a call,
the other party's
voice is hard to
listen to or too
loud • Is Receiver volume in "Volume" changed?
→P101
Images or
melodies set for
each function
do not work and
default settings
are used • Is the same UIM, used when obtaining images
or melodies inserted?→P44
Mail cannot
be received
automatically • Is "Receive option set" in mail settings set to
"ON"? Set to "OFF".→P168
Cannot connect
to i-mode, i-mode
mail, i-αppli, or
i-Channel • Is "Host selection" set to other than "imode"?
→P199
• If subscribing to i-mode while operating, turn
the FOMA terminal off and on again.
i-mode mark
continues blinking
and does not
disappear • When i-mode connection is terminated after
or while checking new messages to the
i-mode center or receiving mails, i-mode mark
continues blinking. If data communication is
not performed, it is automatically interrupted,
but pressing
P
terminates the connection
immediately.
Continued on next page