Docomo F-08d, Инструкция по эксплуатации

Страница: 79 / 171

Settings
77
◆ Setting Airplane mode
When Airplane mode is set, wireless functions of the
terminal (phone, packet communication, Wi-Fi, tethering,
Bluetooth function, FM transmitter) are disabled.
1
From the Home screen,
m
→ [Settings]
→ [Wireless & networks]
2
Mark [Airplane mode]
◆ Wi-Fi
With Wi-Fi function of the terminal, you can use mail or
access the Internet by connecting to the home or company
network or public wireless LAN access point.
To connect to a LAN access point, you need to set
connection information.
■ Reception interference caused by Bluetooth
Wireless LAN (IEEE802.11b/g/n) and Bluetooth function
use the same frequency band (2.4GHz). If you use the
wireless LAN function and Bluetooth function of the
terminal at the same time, reception interference may
occur and the communications speed may lower. Also,
you may hear noise or have a connection problem.
Even when you use only wireless LAN function of the
terminal, the same problem may occur when someone
uses a Bluetooth device near you. In these cases, do the
following.
･
Keep the terminal over 10 meters away from a Bluetooth
device.
･
Within 10 meters, turn off the Bluetooth device.
■ Available channels
1 - 13 channel frequency bands can be used in Japan, and
1 - 11 channel frequency bands overseas.
❖
Connecting to network with Wi-Fi ON
1
From the Home screen,
m
→ [Settings]
→
[Wireless & networks]
2
Mark [Wi-Fi]
Wi-Fi is ON and available Wi-Fi networks are scanned.
･
You can also set Bluetooth to ON/OFF by the setting
button on the Notification panel.
3
[Wi-Fi settings]
Detected Wi-Fi network names and the security
settings (open network or protected network) are
displayed in Wi-Fi network list.
4
Select a Wi-Fi network → [Connect]
･
When you select a Wi-Fi network protected by
security, enter a password (security key) and tap
[Connect].
✔
INFORMATION
･
Even when Wi-Fi is ON, packet communication is
available. However, while you connect Wi-Fi network, Wi-
Fi comes first. When the Wi-Fi network is disconnected, it
switches to 3G/GPRS network connection automatically.
Note that packet communication fee applies for using 3G/
GPRS network.
･
If "Connected (Failed to acquire IP address. Check your
network configuration and password)." appears, Auto-IP
connection is applied and Internet connection including
application communications is not available. To connect
to the Internet, check the signal condition, password
(security code) and make another setting.