DoAll C-3028NC Boxed, Инструкция по эксплуатации

Страница: 26 / 45

21
CONTROL CONSOLE (Continued…)
Other Controls
1. Variable Vise Pressure . Located on the left side of
the machine behind the control console, these
valves are used to adjust vise clamping force against
materials which cannot tolerate full vise clamping
pressure (thin wall tubing, light structural, etc.). This
control can be used with or without the nesting
fixture.
Variable Vise Pressure Controls.

Clamping pressure is set with the index vise and
fixed vise knobs until the desired pressure is
shown by the indicator gauges. Turn each knob
clockwise
to INCREASE the pressure,
counterclockwise to DECREASE the pressure.

When the desired pressure has been reached,
tighten the locking knob to hold the setting/
2. Band Tension Control . Located at the left side of
the machine at the end of the band tension cylinder,
this selector switch, with “OFF”, “HOLD” and “ON”
settings are used when changing saw bands.
Band Tension Control.

Turning the selector to “OFF” releases band
tension and enables saw band removal or
installation.

The “HOLD” setting stops band tension cylinder
movement and allows operator to position the
saw band over the band wheels.

The “ON” setting pressurizes the cylinder and
establishes band tension required for cutting.
The band tension selector must be at “ON”
before the saw head will descend or band drive
motor will start.
OPERATOR WORKSTATION
1. Most of the machine controls are on the operator
workstation.
2. Most screens have a “FN” key in the upper right
corner. Pressing this key gives access to other
screens:
F1 – View Screen
F2 – Run (Manual) Screen
F3 – Alarm Message Screen
F4 – Error Message Screen
DEV – Deviation Monitor Screen (Optional)
SYS – System Screen (hold 5 seconds)
Keypad
1. When the operator presses as key where data may
be entered, a keypad will be displayed.
Keypad.
2. Features of the keypad include:
‐
Display Window. Located at the top of the
window, the display shows the value entered.
3. Data Limits. Below the display window a LOW and
HIGH value can be shown. These values are the low
and high limits of the data that can be entered for
that function.