DoAll C-3028NC Boxed, Инструкция по эксплуатации

Страница: 25 / 45

20
CONTROL CONSOLE (Continued…)
7. Index Reverse . Push and hold this button to move
the index vise backwards. Release the button to
stop the movement.

When then index vise reaches the rear limit,
the yellow light shines.
8. Creep Speed . When this button is pushed and held,
the indexing vise speed is reduced to slow in either
direction. The button is a memory type to hold last
position.
9. Index Vise Open . When this button is pushed and
held, the moveable index jaw retracts from the
fixed vise jaw. Release the button to stop
movement.
10. Index Vise Clamp . When this button is pushed and
held, the moveable index jaw clamps towards the
fixed vise jaw. Release the button to stop
movement.

When the index vise is clamping, the yellow
light shines.
11. Front Vise Open . When this button is pushed and
held, the moveable front vise jaw retracts from the
fixed vise jaw. Release the button to stop the
movement.
12. Front Vise Clamp . When this button is pushed and
held, the moveable front jaw clamps towards the
fixed vise jaw. Release the button to stop
movement.

When the front vise is clamping, the yellow
light shines.
13. Saw Head Down . When this button is pushed and
held, the saw head lowers. Release the button to
stop movement.

When the saw head reaches the lower limit,
the yellow light shines.
14. Saw Head Up . When this button is pushed and held,
the saw head rises. Release the button to stop
movement.

When the saw head reaches the upper limit,
the yellow light shines.
15. Operator Workstation . The operator workstation
has most of the controls to operate the machine.
See the heading ‘OPERATOR WORKSTATION’ later
in this chapter for information on controls and their
use.
Hydraulic Panel
1. Feed Force . Set the feed force by turning the upper
knob to material being cut. The chart of material is
color coded to give a force range the operator can
choose from. Turn the knob clockwise to INCREASE
pressure, counterclockwise to DECREASE it.
Turning the Feed Force control knob to zero (0)
will not stop sawing head motion.
Hydraulic Panel.
2. Feed Rate . Turn the lower knob to the best suited
cutting rate to fit the needs such as cutting time or
cut finish, etc. Turn the knob clockwise to INCREASE
the feed rate, counterclockwise to DECREASE it.
Turning the Feed Rate control knob to zero (0)
will not stop sawing head motion.