DoAll C-3028NC Boxed, Инструкция по эксплуатации

Страница: 27 / 45

22
OPERATOR WORKSTATION (Continued…)
4. 0‐9, decimal point, +/‐ . These keys are used to
enter values for that function. Enter them in order
including the decimal point.
5. CLR (clear) . This will clear the entry in the display.
6. DEL (delete) . Pressing this key will delete the last
keystroke entered.
If you make an error in entering data, just press
the DELETE or CLEAR key, correct or reenter
your value and press the OK key.
7. ENTER . Pressing this key will enter the data into
memory and then will return to the previous screen.
View Screen
Number in text refers to identical number on
illustration.
1 2 3 4 5 6 7
14 13 12 11 10 9 8
View Screen.
1. Displays the current job number performed.
2. LENGTH . Displays length for current job. When
different lengths are required, see chapter SETUP
FOR A JOB later in this section.
3. MOVE QTY . Displays actual position of the index
vise.
4. QTY (quantity). Displays the number to be cut.
5. COUNT . Displays the quantity that has been cut.
6. MODE SET . Used to select operation mode. Press
the MANUAL key for entering manual operation
mode. Press the AUTO key for entering automatic
mode.
7. FN (function). Pressing this key will take the
operator to other screens as described earlier.
8. Displays the current date.
9. COOLANT . When the machine is not in cutting
operation, push on O (changes into I ) will start the
coolant pump. Press again to stop the flow. Press
the AUTO key before cutting operation. The coolant
will automatically flow when the saw blade is
running. When cutting stops, the coolant flow will
stop.
10. Displays the current time.
11. LAMP . Switches to turn lamp on ( I ) or off ( O ).
12. COUNTED . In automatic mode, if the front end of
the material is useable, the first cut is counted, or
otherwise
NOT COUNTED . The function is preset. If
the front‐end material is good press, press NOT
COUNTED after the cutting is started. It will then
show COUNTED . This function is effective only
when pressing COUNTED/NOT COUNTED directly
after the auto cycle cutting is started.
13. BAND SPEED . Displays the band speed in m/min or
in feet/min. depending on machine setting.
14. PHOTOCELL ON/OFF . To turn the out‐of‐stock
photo switch OF or ON.

Press the FN key and select F1 will bring the
operator back to the View Screen.

Press the FN key and select F2 brings the
operator to the Run Screen.