dixell COOL MATE XLR470, Руководство по эксплуатации

Страница: 6 / 18

dIXEL
dIXEL dIXEL
dIXEL
Operating manual cod. 1592 cod. 1592 cod. 1592 cod. 1592017 017 017 017050 050 050 050
1592017050 XLR470 GB r1.0 24.05.07.doc XLR470 6/18
+
To lock and unlock the keyboard.
+ To enter the programming mode.
+
To exit the programming mode.
1.4 MEANING OF THE ICONS
ICON FUNCTION MEANING
ON Celsius degree
ON Fahrenheit degree
ON Compressor 1 on
FLASHING Anti-short cycle delay enabled for compressor 1
ON Compressor 2 on
FLASHING Anti-short cycle delay enabled for compressor 2
ON Defrost 1 in progress
FLASHING Drip time in progress for section 1
ON Defrost 2 in progress
ON Fan1 enabled
FLASHING Drip time in progress – section 1
ON Fan2 enabled
FLASHING Drip time in progress– section 2
ON ALARM signal
1.5 HOW TO SEE AND MODIFY THE SET-POINT
Push and release the SET1 or SET2 key:
the bottom display shows the label St1 or St2
the upper display shows the Set point value flashing
To change the Set value push the
o o o o
or
n n n n
within 15s.
To memorise the new set point value push the SET1 or SET2 key again or wait 15s.
1.6 HOW TO START A MANUAL DEFROST FOR THE SECTION 1 OR SECTION 2
To start a defrost for the section 1 : push the DOWN key( ) for 3s.
To start a defrost for the section 2 : push the UP key( ) for 3s.
1.7 HOW TO ENTER THE “PR1” PARAMETER LIST
To change the parameter’s value operate as follows:
Enter the Programming mode by pressing the
Set1 and DOWN key for 3s
The controller will show the first parameter present in the Pr1 menu:
Bottom menu: label
Upper menu: value
To exit : Press SET + UP or wait 15s without pressing a key.
1.8 HOW TO ENTER IN PARAMETERS LIST “PR2”
To access parameters in “ Pr2 ”:
Enter the “Pr1” level.
Select “Pr2” – “PAS” parameter and press the “
SET1 ” key.
The flashing value “0 - - ” is displayed. use
o
o o
o
or
n
n n
n
to input the security code and confirm the figure by pressing “ SET ” key.
The security code is “321”.
If the security code is correct the access to “Pr2” is enabled by pressing “
SET1 ” on the last digit.
Another possibility is the following:
After switching ON the instrument, within 30 seconds, push
SET1 +
n n n n
keys together for 3s: the Pr2 menu will be entered.