DITTING KE640 2.0, Оригинальное руководство пользователя

Страница: 15 / 40

15
KE640 2.0 | EN
6. Seal the bean container by swiveling in the sliding valve (16) (see Fig. D ).
7. Place the drip tray
(10)
into the corresponding opening under the
outlet (13) .
8. Make sure that the grinder is switched off (On/Off switch (19) to “0”) and
connect the grinder to the power supply by inserting the power plug (18)
into a properly installed safety socket.
Setting up the portafilter support
For grinders designed for mains voltage ranges of 200–230 V
or 220–240 V, the portafilter support is attached with hexagon
socket screws. Use the 3 mm Allen key supplied with this model
for fixing.
For grinders designed for a mains voltage range of 100–127 V,
the portafilter support is attached with slotted screws. You will
need a slot screwdriver for fixing (not included with delivery).
Adjust the portafilter support (7) to the size of your espresso machine’s por-
tafilter (see
Fig. E
):
1. Make sure that the grinder is switched off and not connected to a power
supply (On/Off switch (19) to position “0”).
2. Turn anticlockwise using a slot screwdriver or the 3 mm Allen key sup-
plied to loosen the screws
(6)
for adjusting the portafilter support (left
and right). The portafilter support is lowered as far as it will go.
3. Insert the portafilter into the portafilter support (12) .
4. Push the portafilter support upwards until the portafilter fits exactly
between the portafilter support and the portafilter intake.
If the portafilter support does not fit, contact your supplier (see
chapter “Maintenance and service”).
5. Hold the portafilter support in position and fix it by turning the screws
for adjusting the portafilter support (left and right) until tight using a slot
screwdriver or the 3 mm Allen key supplied.