Dish Network DuoDVR ViP 622, Руководство пользователя

Страница: 94 / 170

Remote Controls
85
Controlling Other Components
4
To start learning commands for this mode:
• If you've found a code for that
device, first program the code.
Now press and release RECALL,
then press and hold the RECORD
button for about three seconds.
• If you have not programmed a
code for that device, press and
hold RECORD for three seconds.
To find and program the device code, use the
instructions for Setting Up Using Device Code
Tables or Setting Up Using Device Codes
Scan.
The device mode button that you selected
remains lit while learning.
5
Point the front of the original device remote
to face the small square (IR window) on the
front, left-hand side of the DISH Network
remote control, as shown on page 84.
6
On the DISH Network remote control,
press the button you want to teach.
7
On the original device’s remote control,
press and hold the button for the command
that you want learned.
• If the DISH Network remote learns
the command, the device mode
light blinks off and then back on.
• If the mode light blinks three times
or remains lit, the DISH Network
remote did not learn the command.
You may need to try pressing the button on the
original device’s remote several times for the
DISH Network remote to learn the command.
8
After a button has learned a command suc-
cessfully, repeat step 6 and step 7 until all
commands you want have been learned.
9
To end the learning sequence:
• Press one of the mode buttons on
the DISH Network remote. This
saves all the commands for that
mode, and exits learning to return
to normal remote control operation.
• To cancel learning, do not press
any buttons on either remote
control for at least 30 seconds. The
DISH Network remote control
times out of learning and returns to
its normal operation.
Note that no learned commands
are saved if the DISH Network
remote control times out before
completion of learning.
The learning sequence also ends if the remote:
• Runs out of memory for learned
commands, whereupon it saves
the commands you have learned
for equipment in this mode, exits
learning and returns to its normal
remote control operation. Then the
DISH Network remote cannot learn
any additional commands.
• Batteries are too low for learning,
when all the mode buttons blink
quickly eight times. Learning ends
with no learned commands
saved, and the DISH Network
remote control returns to its normal
operation.
Change the remote’s batteries.