Dish Network DuoDVR ViP 622, Руководство пользователя, Страница: 93 / 170

84
Controlling Other Components
Chapter 10
Setting Up by Learning from Another Remote
After you have programmed your DISH Network remote to control your devices (in TV,
DVD, and/or AUX modes), you may find not all of the commands used by the devices’
original remote controls function as you expect. The learning function of your new DISH
Network remote control can support these commands.
The remote control can learn commands in two ways:
1
You can follow the instructions for using device codes to program a specific mode, and
then learn commands that add new or overwrite existing functions of the remote control’s
buttons in this mode. For this type of learning, any remote control button without a learned
command keeps the pre-existing command (if any) for that programmed device code.
2
Each button on this remote control can learn a command from the equipment’s original
remote control. For this type of learning, any remote control button without a learned
command will have no function for that programmed device.
To “teach” your DISH Network remote control buttons specific commands for your devices,
complete the following:
Instructions Additional Information
1
Ensure the the desired remote address is
programmed to the DISH Network remote.
See “Checking the Remote Control Address”
on page 75.
2
Place both your DISH Network remote and
the original equipment’s remote control on
a flat, stable surface.
Holding either remote control in your hand may
cause learning to fail.
3
On the DISH Network remote, press and
hold the mode button for your equipment
for about three seconds until all the mode
buttons light up, and then release it.
Your selected mode button will blink.