Dish Network DuoDVR ViP 622, Руководство пользователя

Страница: 118 / 170

Connections and Setup
109
Connecting to the Remote TVs (TV1 or TV2)
15
Confirm that you see a picture from the receiver on your remote TVs.
• If your picture looks good, go to step 23.
• If your TVs do not have a picture or if it is not as clear as you would like it to be, go to
the next step.
16
You may need to change the cable connection on the splitter that sends the TV signal
throughout your house. The change that needs to be made is to reconnect the cable
coming from the receiver H
OME
D
ISTRIBUTION
from the output of the splitter to the input of
the splitter using the instructions that follow.
The following figure shows an example of what your splitter may look like. Your splitter
may look different. The places where the splitter indicates O
UT
refers to all TVs connected
to your cable system. The places where the splitter indicates I
N
refers to where the TV
signal is fed into the splitter.
17
Find where the TV signal is distributed throughout your house. It should be near where the
cable TV service enters the house.
18
Disconnect the cable TV service cable or antenna cable from the splitter input, if
necessary. Make sure the disconnected cable is capped or otherwise protected from the
weather.
19
Disconnect the cable coming from the receiver H
OME
D
ISTRIBUTION
port from the splitter. If
you do not know which cable this is, go to the next step. Otherwise, go to step 21.
20
If you have multiple TVs on the cable system, do the following to determine which cable
on the splitter is coming from the receiver:
• If you have at least some picture on your TVs, turn on all remote TVs connected to the
cable system. Disconnect and reconnect each cable one-by-one, observing what
happens to the TVs. When all remote TVs lose the signal, you have disconnected the
receiver’s cable. If only some or one TV loses the signal, then you have disconnected
a cable from the TVs.
• If the above step does not work, disconnect one of the output cables and connect to
the splitter input. If you do not see a picture, connect the cable back to its output.
Repeat this step on every connection until you get a picture on the remote TV(s).
1 Input, 4 Output (4-Way) Splitter