9
Important: You should not upgrade your autoloader's firmware unless your system is
becoming unstable or you are advised to do so by Tech Support.
13. Loader Utilities
page 36
Use the Loader Utilities menu options to access the various utilities built into the autoloader. You
can scroll between the various options using the Up or Down button.
1. Drive Alignment
The Drive Alignment menu is used to check the mechanical alignment between the drives
and the robotic arm. See Drive Alignment on page 36 for more information.
2. Spindle Alignment
The Spindle Alignment menu is used to check the mechanical alignment between the
spindles and the robotic arm. See Spindle Alignment on page 37 for more information.
3. Disc Separator
Use this utility to tell the system the number of times for the robotic arm to shake the disc it
picked up from the input spindle in order to reduce the disc sticking issue. See Disc Static
and Sticky Media Issues on page 2 for information about disc sticking issue and Disc
Separator on page 38 for information on using this menu.
4. Z form Maneuver
Use this utility to enable or disable the Z form maneuver. See Z form Maneuver on page
38 for information on using this menu.
5. Alignment Protection
Enabling Alignment Protection makes each drive tray quickly slide in and out after a disc
has been loaded into it. This ensures that the disc sits properly in the disc indentation of the
tray by shaking the disc into place. See Alignment Protection on page 38.
14. Manage Accounts
page 39
Use this menu option to:
Create user accounts and passwords to prevent unauthorized use of the autoloader.
Edit existing user account information, including name and password.
Delete existing user account(s).
Enable/Disable this feature.
For additional information, refer to Introduction to Manage Accounts on page 10.
15. Shutdown
page 41
Use this menu option to turn off your system. Once you see the Ready to Power Off message, you
can safely turn off the machine using the power switch. Turning off your autoloader without
performing this function increases the risk of damaging it.
16. AUTOCOPY (Hidden)
page 30
The AUTOCOPY function simplifies the copy process by allowing you to stack blank media on a
spindle(s), place the master on top of the stack on the first spindle, and press the Enter button on
16.AUTOCOPY key in the main menu. It will load the content of the top disc of the 1
st
input spindle
(master disc) into the Reserved Partition of the Hard Drive and copy it to blank disc(s) below it and
other input spindle(s) if exists.
To activate this function, you need to activate it by going to 11. Setup -> 9.AUTOCOPY and turn
it on.