Dinolift DINO 280RXT, Руководство по эксплуатации

Страница: 44 / 74

44
Operating instructions • DINO 280RXT
To adjust the stabilisers individually:
5. Select direction of movement with selection buttons. A
signal light on the button will indicate that the function is
active. The function will deactivate:
• when the button is pressed again,
• a different stabiliser function is selected or
• no movement has been driven for 5 seconds.
54.1676
54.1674 54.1673
54.1676
KG
54.1769
54.1770
6. Select the stabiliser you want to operate by turning the left
joystic. Each stabiliser can be used separately or they can
be used two at a time.
54.1676
54.1674 54.1673
54.1676
KG
54.1769
54.1770
NOTE! Stabiliser controls reverse their operating direction if the turning device is reversed
with respect to the chassis.
While using stabilisers, ensure
• the unobstructed operating range.
• the wheels are off the ground and the footplates are lower than the wheels
• the stabilisers are firmly supported and cannot slide on a gradient
When raising the stabilisers make sure they are fully retracted before driving. Avoid damage
caused by contact to the ground.
DANGER
WARNING
CAUTION
NOTICE
Risk of turning over the lift! Using the lift is prohibited unless it is properly supported.
Observe the effect of ice, possible rain and inclination of the surface on the support force
(the stabilisers must not slip on the surface).
As required, test the stability by turning the boom around loaded but the telescope fully
retracted. If you notice that the chassis inclines during the test, you must not continue the
use.