Dinolift DINO 280RXT, Руководство по эксплуатации

Страница: 43 / 74

43
5.2.2. Support position
The stabilizers can only be operated, while the
articulated arms and boom are on the support
and the telescopic boom is fully retracted.
1. Attach the safety harness to the anchor point on the platform.
2. Activate controls with activation pedal.
None of the movements may be activated. The pedal must be kept
active throughout the operation.
If the pedal is held down for more than 10 seconds, and no movement
is activated during this time the pedal must be released and re-activated
To use the stabilizers with automatic levelling function:
1. Select automatic levelling mode with selection button. A
signal light on the button will indicate that the function is
active. The function will deactivate:
• when the button is pressed again,
• a different stabiliser function is selected or
• no movement has been driven for 5 seconds.
54.1676
54.1674 54.1673
54.1676
KG
54.1769
54.1770
2. Select the direction of movement by turning the middle
joystick. Keep the levelling operation activated until the
movement stops.
54.1676
54.1674 54.1673
54.1676
KG
54.1769
54.1770
3. Verify the level position of the lift.
The electronic display with columns indicates when the
horizontal position is reached.
The operation of the display is the following.
• The columns indicate that the chassis lies higher on that
side than on the opposite side. The numbers indicate the
inclination angle.
• When the signal is on only in the centre, the chassis is at
level position.
0,0
0,0
0,0 0,0
LIMITER:
XXXXXOOOOO
FUEL LEVEL OK
AERIAL: OK
STAB: (OOOO) OK
RUN TIME: 80:00
READY
• Black stabiliser markings on the display indicate that the
stabiliser is pressed to the ground.
4. Readjust manually, as necessary.