Dinolift DINO 280RXT, Руководство по эксплуатации

Страница: 27 / 74

27
8. Emergency stop buttons
Pressing down the emergency stop button shuts down the control system, stops all the
movements immediately and turns off the power unit. A button can be found at each control
station.
When the machine is in emergency stop mode, red lights flash on all control buttons and the
indicator light in the LCB center emergency stop button goes out.
The emergency stop button locks in the lower position, and it must be released before
starting the power unit.
DANGER
WARNING
CAUTION
NOTICE
If the unit does not start, make sure that the emergency stop button is not in the lower
position at any of the control stations.
9. Emergency descent system
As a precaution against possible failure in the power supply, the lift is
equipped with a battery operated emergency descent system.
The diesel engine stops once the emergency descent system is started.
The emergency descent system can be used from either control station regardless of the
control station selection. Starting the emergency descent system activates the control station
from where it’s used and deactivates the other control station.
The emergency descent system allows the operation of all other movements, except
telescope extension and articulated arms up. All normal safety devices remain operational
during emergency system operation.
EMERGENCY DESCENT SYSTEM IN EMERGENCY STOP MODE
If the emergency stop button has been pressed, the emergency descend system can only
be operated from the ground level. Emergency stop disables the normal control system and
safety devices and only the manually controlled system remains operational.
DANGER
WARNING
CAUTION
NOTICE
Risk of turning over the lift and serious structural damage!
Manual operation of the
valves overrides critical safety devices. For this reason, the operating lever has been
sealed. The system should only be used to rescue a trapped operator in an emergency in
case normal control system can not be operated.