mand station. The DB150 beeps once to indicate that it has sent the program-
ming command. Power districts connected to expansion boosters will not
receive the programming commands.
15.1 Using the DT400’s key pad in Programming Mode
Before programming is discussed it is useful to explain how the DT400 enters
CV numbers and values. CV #’s 000-255 can be directly entered from the key
pad when the throttle is in program mode and the indicator is displayed on the
Left side of the LCD. If you try to enter a CV Number above 255, the throttle
will automatically return the display to 000.
Use the DT400 key pad to enter CV Numbers
while in Programming Mode
Example: Key in CV47
Press the "4 Key"
CV# 004 is displayed
Press the "7 Key"
CV# 047 is displayed
Press the "8 Key"
CV# Returns to 000
CV#'s above 255 can't be
directly entered. See below.
To Program Stationary Decoder CV's
Press the "R Reverse Key" CV#512 is displayed
Use the L throttle knob to dial in CV#'s 512-767 to
program stationary decoder CV's. Press the "R reverse Key"
again to return to CV range 001-255
Note: The DT400 Key pad does not work in the address
range 512-767, you must use the L Throttle Knob
to dial up CV Numbers in that range.
67
