Digital Projection TITAN sx+ 3D, Руководство пользователя

Страница: 64 / 168

Page 4.14 Rev C April 2011
4. Controlling the projector
Digital Projection
TITAN sx+ 3D, Dual 3D, Ultra Contrast
User Manual
For important information about how Input 8 is used, see
INPUT 8 in the Notes column
, and also Section 4, Overview.
Notes
For more information about
input modes and input presets,
see earlier in this section, Input
modes and settings.
See also Input menu, later in
this section.
A preset can be applied only to
the same mode for which it was
created. If the detected input
mode does not match, then
settings from the mode history
or mode library will be applied.
For more information about
input modes, see Input modes
and settings. earlier in this
section.
The lens settings, ie Focus
position, Zoom position and
Shift, are included only for the
first ten presets.
The lens settings are the only
settings saved for Input 8.
The red, green and blue keys
are disabled when the OSD is
switched OFF.
For more information about test
patterns, see Setup menu, later
in this section.
Input Presets
recall
To recall a set of modal and lens settings that have been saved, press and hold
, whilst pressing the lettered key A – S.
The projector will switch to the saved input source, and redetect the input mode
before applying the saved modal and lens settings.
Save
To save the current input source, modal and lens settings, press and hold ,
whilst pressing the lettered key A – S.
If this Preset has been used before, and the Input source has been changed,
then the following message will be displayed.
Press and to select either OK or Cancel.
Press to confirm your selection.
The settings will be saved to the selected preset, and the following message will
be displayed.
Red, Green and Blue
Press , or to switch the red, green or blue components OFF
or ON.
Test pattern
Press to select a test pattern.
•
•
•
•
•
•
•
•