Digital Projection TITAN sx+ 3D, Руководство пользователя

Страница: 38 / 168

Page 2.14 Rev C April 2011
2. Installation Digital Projection
TITAN sx+ 3D, Dual 3D, Ultra Contrast
User Manual
Adjusting the rigging frame
Coarse adjustment of projector level should be made by adjusting the length of
the supporting wires or chains, or by adjusting the position of the truss or rigging.
Once the initial coarse adjustment has been made, fine adjustment can be made by
turning the frame adjusters on the rigging frame:
To tilt the projector forwards and backwards (pitch adjustment),
turn either the front pair or the rear pair of vertical adjusters,
taking care to turn both adjusters by the same amount.
To tilt the projector from side to side (roll adjustment), turn either
the left pair or the right pair of vertical adjusters, taking care to
turn both adjusters by the same amount.
To rotate the projector around its vertical axis (yaw adjustment),
turn the single horizontal adjuster at the rear.
•
•
•
Vertical
adjusters
Horizontal
adjuster
Notes
Before suspending the
projector, make sure that all the
frame adjusters are set midway.
Always make adjustments in
pairs - never make a single
adjustment - otherwise
the projector frame could
become distorted.
Do not tilt the projector more
than ±10° in either direction
when in use, as this may
cause serious lamp failure,
damage the lamp module
and cause extra cost on
replacement.
It may be possible to use
the projector in other
orientations, depending on
lamp configuration. For more
information, contact Digital
Projection.
±10°
±10°