Digital Projection TITAN sx+ 3D, Руководство пользователя

Страница: 50 / 168

Page 3.4 Rev C April 2011
3. Getting Started Digital Projection
TITAN sx+ 3D, Dual 3D, Ultra Contrast
User Manual
Adjusting the projected image
Picture settings
Press a key, followed by and to adjust these picture settings:
Brightness BRI
Contrast CON
Saturation SAT
Phase PHASE
Aspect ratio ASPECT
Geometry settings
Press Keystone KEYST
followed by and to adjust the keystone correction.
Press Position POS (for all inputs except DVI)
followed by , , and to adjust the picture position, for images
smaller than the DMD.
Switching the projector off
Press POWER on the remote control or keypad, and hold for 3 seconds,
to switch the projector OFF.
•
•
•
•
Notes
The Saturation control is
available for Composite, S-
Video and Component inputs
only.
The Phase control is available
for RGB inputs only.
None of the Geometry controls
are available for Input 8.
For more detailed information
about:
- using the control keys on the
remote control or keypad,
- using the menus,
see the next section:
Controlling the projector.
For all adjustments that require
more than one key to be
pressed:
- after 10 seconds, if no
adjustment has been made,
the indicator will go out and
the adjustment key must be
pressed again.
- to end the adjustment before
10 seconds has elapsed, press
a different adjustment key, or
press the Exit key.
Always allow the lamp to cool
for 5 minutes before:
- disconnecting the power
- moving the projector