Installing Your System
2.3 Connecting System Components
2.3 Connecting System Components
After unpacking, follow the instructions in Sections 2.3.1 through 2.3.7 to
connect system components.
2.3.1 Identify the System Unit Ports and Connectors
Figure 2–2 shows all the ports and connectors on the rear of an InfoServer
150 system. Take some time to become familiar with the ports and connectors.
Symbols (called icons) identify each port and connector you will use when
installing your system. Note that there are two SCSI ports. SCSI port A is at
the upper left and SCSI port B is next to it.
Figure 2–2 Ports and Connectors
On/Off Switch
System AC Power
SCSI Port
Standard Ethernet
Connector
Standard Ethernet Light
Network Select Button
ThinWire Ethernet Light
ThinWire Ethernet
Connector
Halt Button
MMJ Ports
Break Enable Switch
(For Field Service Use Only)
Diagnostic LEDs
1
M M J P o r t
( N o t U s e d )
M K V - X 3 1 2 7 - 9 1
Note
Not all of the connectors shown are usable. In particular, MMJ ports 2
and 3 and the modem port (to the left of MMJ port 1) are not supported
by the server.
2–4
