Digisol DG-FS4526E, Руководство по управлению

Страница: 553 / 1162

C
HAPTER
19 | Using the Command Line Interface
Entering Commands
– 553 –
N
OTE
:
You can open up to four sessions to the device via Telnet.
E
NTERING
C
OMMANDS
This section describes how to enter CLI commands.
K
EYWORDS AND
A
RGUMENTS
A CLI command is a series of keywords and arguments. Keywords identify
a command, and arguments specify configuration parameters. For
example, in the command “show interfaces status ethernet 1/5,” show
interfaces and status are keywords, ethernet is an argument that
specifies the interface type, and 1/5 specifies the unit/port.
You can enter commands as follows:
To enter a simple command, enter the command keyword.
To enter multiple commands, enter each command in the required
order. For example, to enable Privileged Exec command mode, and
display the startup configuration, enter:
Console> enable
Console# show startup-config
To enter commands that require parameters, enter the required
parameters after the command keyword. For example, to set a
password for the administrator, enter:
Console(config)# username admin password 0 smith
M
INIMUM
A
BBREVIATION
The CLI will accept a minimum number of characters that uniquely identify
a command. For example, the command “configure” can be entered as
con . If an entry is ambiguous, the system will prompt for further input.
C
OMMAND
C
OMPLETION
If you terminate input with a Tab key, the CLI will print the remaining
characters of a partial keyword up to the point of ambiguity. In the “logging
history” example, typing log followed by a tab will result in printing the
command up to “ logging .”