Digisol DG-FS4526E, Руководство по управлению

Страница: 1034 / 1162

C
HAPTER
40 | CFM Commands
– 1034 –
ethernet cfm mep
This command sets an interface as a domain boundary, defines it as a
maintenance end point (MEP), and sets direction of the MEP in regard to
sending and receiving CFM messages. Use the no form to delete a MEP.
S
YNTAX
ethernet cfm mep mpid mpid md domain-name ma ma-name [ up ]
no ethernet cfm mep mpid mpid ma ma-name
mpid – Maintenance end point identifier. (Range: 1-8191)
domain-name – Domain name. (Range: 1-43 alphanumeric
characters)
ma-name – Maintenance association name. (Range: 1-45
alphanumeric characters)
up – Indicates that the MEP faces inward toward the switch cross-
connect matrix, and transmits CFM messages towards, and receives
them from, the direction of the internal bridge relay mechanism. If
the up keyword is not included in this command, then the MEP is
facing away from the switch, and transmits CFM messages towards,
and receives them from, the direction of the physical medium.
D
EFAULT
S
ETTING
No MEPs are configured.
The MEP faces outward (down).
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
U
SAGE
CFM elements must be configured in the following order: (1)
maintenance domain at the same level as the MEP to be configured
(using the ethernet cfm domain command), (2) maintenance
association within the domain (using the ma index name vlan
command), and (3) finally the MEP using this command.
An interface may belong to more than one domain. This command can
be used to configure an interface as a MEP for different MAs in different
domains.
To change the MEP’s MA or the direction it faces, first delete the MEP,
and then create a new one.
E
XAMPLE
This example sets port 1 as a DSAP for the specified maintenance
association.
Console(config)#interface ethernet 1/1
Console(config-if)#ethernet cfm mep mpid 1 md voip ma rd
Console(config-if)#