Digisol DG-FS4526E, Руководство по управлению

Страница: 1031 / 1162

C
HAPTER
40 | CFM Commands
– 1031 –
Also note that while MEPs are active agents which can initiate
consistency check messages (CCMs), transmit loop back or link trace
messages, and maintain the local CCM database. MIPs, on the other
hand are passive agents which can only validate received CFM
messages, and respond to loop back and link trace messages.
The MIP creation method defined by the
ma index name vlan command
takes precedence over the method defined by this command.
E
XAMPLE
This example creates a maintenance domain set to maintenance level 3,
and enters CFM configuration mode for this domain.
Console(config)#ethernet cfm domain index 1 name voip level 3 mip-creation
explicit
Console(config-ether-cfm)#
R
ELATED
C
OMMANDS
ma index name vlan (1032)
ethernet cfm enable
This command enables CFM processing globally on the switch. Use the no
form to disable CFM processing globally.
S
YNTAX
[ no ] ethernet cfm enable
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
To avoid generating an excessive number of traps, the complete CFM
maintenance structure and process parameters should be configured
prior to globally enabling CFM processing with this command.
Specifically, the maintenance domains, maintenance associations, and
MEPs should be configured on each participating bridge.
When CFM is enabled, hardware resources are allocated for CFM
processing.
E
XAMPLE
This example enables CFM globally on the switch.
Console(config)#ethernet cfm enable
Console(config)#