digicon dTower, Руководство по эксплуатации продукта

Страница: 13 / 48

13
6. Installing and assembling
6.1 Unboxing
As is customizable, it is important to perform a cautious visual inspection
dTower
before the installing and assembling processes. In case of missing pieces, immediately
contact the Digicon representative responsible for the sale.
Ÿ
Ÿ
Two people are necessary to remove the equipment from the box;
Ÿ
The top flaps of the box can be folded in the middle, facilitating access to the
equipment;
Ÿ
Be careful when removing the equipment from its box not to damage it
6.2 Pre-installation
Before starting installation of , the floor where the equipment will be installed dTower
must be ready. The built-in boxes must be installed before affixing the . There is dTower
an opening underneath the equipment and the built-in boxes must be centered on it.
The floor must be steady and levelled to ensure good performance of the equipment.
NOTE
-
Measurements are illustrated in millimeters and (inches).
Tower
WARNING
Allow only qualified personnel to install this equipment. The
installation must meet all the local standards and regulations.
Built-in box
51 (2,007")
173 (6,811")
36
(1,417")
88
(3,464")