digicon dTower, Руководство по эксплуатации продукта

Страница: 15 / 48

15
6.3 Fixation to the floor
The image below indicates the points for fixing the product to the floor.
The surface must be steady and leveled to ensure good performance for the passage-
controlling sensor and to maintain the doors aligned.
Fixing can be done through mechanical bolts, also known as parabolts, or through
chemical anchorage.
Ÿ
For mechanical bolts, minimum floors thickness should be 100mm.
Ÿ
In case of floors with less than 100mm thickness or special floors, use chemical
anchorage.
NOTE –
To facilitate tightening the screws, use a long extensor.
NOTE - Measurements are illustrated in millimeters and (inches).
It is very important to check, upon installation, the alignment of the doors in the closed
position. The distance, from top to bottom, must be the same.
- Fixing points
170
(6,692")
93
(3,661")
Ø15
(0,590")
Tower