digico D5T, Руководство по эксплуатации

Страница: 138 / 166

Chapter 8
8-4
The console has crashed but when it tries to recover the session there is still a problem.
The session file may have become corrupted. Reload the D5T software whilst holding the keyboard
"Shift" key. A Recover and Restart panel will appear which provides different reboot options.
Note: If you hold the Shift key while Windows is rebooting the Surfaces.exe program will not
start and the console will not function correctly. Therefore, load the D5T software then Quit To
Windows using the System / Service Menu and then load the D5T software again whilst holding
the Shift key.
I have an input source selected for a channel but there is no audible signal.
Check that the channel insert is not switched on. If it is switched on but no insert return signal is se-
lected then there will be no audible signal in that channel.
The channel high and low pass filters are not having any effect on my audio signal.
These filters have no effect on internal signals as they are preprocessing.
Internal signals consist of:
1) Talkback mics, tone and noise generators (Misc Input Group).
2) Buss results used as input sources (any input source name preceded by the symbol ~).
3) Returns from the optional internal effects module (Effects Input Group).
I do not seem to have as many Channel Sends available as I should.
The number of Channel Sends available can be seen in the Diagnostics panel under the System menu.
They are used by Direct Outputs, Channel Insert Sends, the internal Effects module and IPC's.
If you are using the internal Effects module:
2 Channel Sends will be used for each stereo effect.
If FX5 and FX6 are set to Output Processing, anything between 4 (2 x stereo masters) and 16 (2 x 7.1
masters) Channel Sends will be used.
How do I tell if a channel is stereo or mono when the input screen is in its standard view?
Stereo channels have two on-screen meters and there is also an "s" below the channel number at the
top of the screen.
How can I change the Pre/Post setting for a single auxiliary send?
To change this setting, use the button beneath the auxiliary send control but make sure that the send is
set to minimum. Using the same button with the send turned up will switch the auxiliary on and off.
I cannot see the Width control for a stereo channel on the screen.
Use the Screen Scroll buttons to move the highlighted line down. The Width control is in the last position
after the Pan control.
I want to trigger a noise gate with an external source but when I press the Key button, the key source
panel doesn't appear.
Check that you haven't selected a dynamics configuration which includes filters. The external trigger is
only available for the first dynamics configuration where the filters are not used.
The audio is sometimes interrupted when I use the channel EQ.
Switching the Channel LPF or HPF Filters in will briefly interrupt the audio in that channel.